12
BATTERY CHARGER
BECOME FAMILIAR WITH THE CHARGER
(See Figure 14.)
Before attempting to use this charger, become familiar with all of its operating features and safety
requirements. This ISM device complies with
Canadian ICES-003
• Power cord with plug
• Charger
Fig. 14
CHARGING THE BATTERY PACK
(See Figure 15.)
WARNING
BATTERY CHARGING PROCEDURE:
• Align the battery pack (2) to the slots on the
charger (1) and slide it in until it locks in place
• Connect the charger (1) to the power supply.
• Allow sufficient charging time (3-5 hours), and then
disconnect the charger from the power supply.
• Press the release button on the battery pack and
remove battery from charger.
NOTE:
It is normal for the battery pack and charger
to become warm (but not hot) during charging process.
If the battery does not charge properly, check to make
sure the electrical outlet is "live".
NOTE:
Always charge the battery before storage!
To reduce risk of fire, never leave the battery
connected with the charger for more than 24 hours!
2
1
• If any part of the charger is missing or damaged, do not operate it until the part is repaired or
replaced. Failure to heed this warning could result in possible serious injury.
• Check the voltage! The voltage must comply with the information on the rating label!
1
2
Fig. 15
Summary of Contents for 24LSC01-ETL
Page 25: ...25 EXPLODED VIEW CLGT2410 EXPLODED VIEW...
Page 27: ...27 NOTES...
Page 51: ...51 VUE CLAT E VUE CLAT E DU MOD LE CLGT2410...
Page 53: ...53 REMARQUES...
