18
15. STOPPING THE GENERATOR
1. Remove the connectors of all electric
equipment from the generator panel.
WARNING
NEVER stop the engine with electrical
devices connected and running.
2. (Suitable for Wireless remote control)
Press the STOP key repeatedly for 2-3
seconds to stop the generator from
running.
NOTE: Replace battery when the control
distance is inadequate, and/or when the
indicator light on remote control is not
functioning. See maintenance section for
more info.
If the generator will not be in use for over
2 weeks, please turn the knob to “OFF”
position, or the battery will be out of
power and the generator can not be
started.
3. Turn the energy saving switch to the
“ON” position.
4. Allow the generator to run at no load
for a few minutes to stabilise internal
temperatures of the engine and generator.
5. Turn the two-in-on switch to ‘‘OFF’’
position.
16. PARALLEL CONNECTION
(If applicable)
Make sure that the generator is in a good
running state before connecting it to other
generators. The total power of electric
devices should not exceed rated power of
generator.
When electric motor starts, the overload
indicator (red) will light up and normally it
will stop within 4 seconds. If it does not
or cannot stop, please consult your local
dealer.
