Fig. 2
D
C
A
B
A - Slot
B - Tube opening
C - Blower Tube
D - Concentrator Nozzle
14
INSTALLING VACUUM TUBE AND COLLECTION BAG WITH SHOULDER
STRAP
See Figure 3-9.
■ Open vacuum gate. (Fig. 3)
■ Unscrew roller wheels, insert the wheel shaft into the aperture under the vacuum tube and screw
down the wheels. (Fig. 4)
■ Align the tabs on the tubes and slide the lower tube into the upper vacuum tube until you hear a
"click"
■ Then position the opening of the upper tube to align with the gate opening. (Fig. 5)
■ With assembled vacuum tube properly aligned, insert into aligned gate opening and using the
latching gate lock, lock vacuum tube into place. Make certain the vacuum tube aligning tab is firmly
"seated" before locking the latch. (Fig. 6)
■ Add collection bag by simply aligning the plastic connector sleeve on the bag to the blower exhaust.
(Fig. 7)
■ While standing in the operating position adjust the length to fit the operator’s size. pull the tab to
lengthen, pull the strap to shorten. ( Fig. 8-9)
ASSEMBLY
ASSEMBLING THE BLOWER TUBE
See Figure 2.
■ Slide blower tube forward until the tab on the blower housing clicks into the slots on the tube.
■ Insert the concentrator nozzle onto the blower tube to lock. (Concentrator nozzle is used to
increase air flow in tight areas: flower beds, under decks, etc.).
Summary of Contents for BV1210E 1201
Page 16: ...16 ASSEMBLY Fig 7 Fig 8 Fig 9...
Page 23: ...23 EXPLODED VIEW...
