21
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
SOLUTION
Unit will not start.
1. Unit is unplugged.
1. Check cord to make sure it is plugged into an
electrical outlet.
2. Power/speed switch is in
the OFF position.
2. Slide switch to high or low.
3. Defective power switch.
3. Call customer service for assistance at (866)
384-8432
4. Vac tubes are not correctly
installed.
4. Check vac tubes to ensure that they are
allowing the switch to be engaged when
correctly installed.
5. Vacuum gate/port is not
closed.
5. Ensure that port/cover is fully closed an
locked.
6. Housing circuit may have
tripped.
6. Check wall circuit breaker panel and reset if
necessary.
7. Motor is overheated or
overcurrented.
7. Turn tool off and wait several minutes for the
motor to cool down.
Unit will not blow
or suck debris.
1. Bag full
1. Empty the bag.
2. Blocked tube
2. Clear the blockage.
3. Blocked impeller
3. Clear the blockage
4. Torn bag
4. Replace the bag.
5. Bag unzipped
5. Zip up the bag.
6. Unit unplugged
6. Plug into an outlet or an extension cord.
7. Motor is overheated or
overcurrented.
7. Turn tool off and wait several minutes for the
motor to cool down.
Summary of Contents for BV1210E 1201
Page 16: ...16 ASSEMBLY Fig 7 Fig 8 Fig 9...
Page 23: ...23 EXPLODED VIEW...
