11
ASSEMBLY
• Press the release button (22) on the battery pack (5) and remove it from the product (Fig. 12).
• Align the battery pack (5) to the slots at the bottom side of the rear safety guard (2) and slide it in
until it locks in place (Fig. 13).
ATTACHING AND REMOVING THE BATTERY PACK
(SEE FIGS. 12-13)
Fig.12
Fig.13
• Unplug the line trimmer.
• Remove the spool from the line head.
• Insert the line into the anchor hole in the upper part of the spool. Wind the line around the upper
part of the spool counterclockwise, as shown by the arrows on the spool. Place line in the slot on
upper spool flange, leaving about 6 in. (152 mm) extended beyond the slot. Do not overfill. After
winding the line, there should be at least 1/4 in. (6 mm) between the wound line and the outside
edge of the spool.
• Install the spool in the line head and replace the spool cover as described in Spool Replacement.
LINE REPLACEMENT (See figs. 10)
NOTE:
Remove any old line remaining on the spool. Cut the line being approximately 9 ft. (2.7 m)
long. Use only 0.065 in. (1.65 mm) diameter monofilament line.
Anchor
Hone
Spool
Fig. 10
Fig. 9
Spool Cover
Spool
Tabs
Eyelets
Slots
Summary of Contents for CLGT1810S01
Page 25: ...25 EXPLODED VIEW CLGT1810S01 EXPLODED VIEW ...
Page 27: ...27 NOTES ...
Page 52: ...VUE ÉCLATÉE VUE ÉCLATÉE DU MODÈLE CLGT1810S01 52 ...
Page 54: ...54 REMARQUES ...
