LawnMaster CLGT2412, Operator'S Manual

16

OPERATION

Use the yoke to keep distance to obstacles that could be hit by the cutting device.
●  Push the Flower Guard (13) to its outer position for operation until it snaps into place (Fig.17).
●  Push the Flower Guard (13) to its inner position after operation and when storing (Fig.18).

FLOWER GUARD 

 ( See Figure 17-18.)

Only use the approriate type of cutting line.

GENERAL OPERATION

Fig. 17 , working position

Fig. 18 , storing position

Adjust the Flower Guard position only when the product is switched off and the cutting device is at 

a complete stop!

■  Check the product, its battery pack and charger as well as accessores for damage before each

    use. Do not use the product if it is damaged or shows wear.

■  Double check thata accessories and trimming blades are properly fixed.
■  Always hold the product by its handles. Keep the handles dry to ensure safe support.
■  Ensure that the air vents are always unobstructed and clear. Clean them if necessary with a soft

    brush. Blocked air vents may lead to overheating and damage the product. 

WARNING:

WARNING:

● Insert the line into the anchor hole in the upper part of the spool. Wind the line around the upper 
   part of the spool counterclockwise, as shown by the arrows on the spool. Place line in the slot on
   upper spool flange, leaving about 6 in. (152 mm) extended beyond the slot. Do not overfill. After
   winding the line, there should be at least 1/4 in. (6 mm) between the wound line and the outside 
   edge of the spool.
● Install the spool in the line head and replace the spool cover as described in Spool Replacement.