11
GB
Assembling instructions
Do not insert the battery until
the appliance is fully assembled.
Risk of injury!
To put on the protective cover:
1. Place the protective cover (14)
on the motor head (10) and
screw it down with the 3 Phillips
screws.
To put on the auxiliary handle:
1. Pull the ends of the auxiliary
handle (5) to extend the han-
dle and slide it over the handle
holder (21).
2. Screw down the screw (22) in
the auxiliary handle (5).
To install the cutting insert:
1. Place the cutting insert (13) on
the pin (23) on the cutting disk
(12) and pull out the insert until it
snaps in.
Spare cutting inserts are kept in the
box (4) on the auxiliary handle (5).
To insert the battery:
1. To insert the battery (16), place it
on the guide track (20) and push
it into the appliance. It will audi-
bly snap in.
Operation
Caution: risk of injury! Do not
operate the appliance without
the protective cover. To oper-
ate the appliance, wear suitable
clothing, eye and ear protection.
Prior to every use, check that
the appliance is operative. Do
not block the On/Off switch or
the switch lock. They must reli-
ably turn off the motor when you
release the switch. Do not oper-
ate the appliance if one of the
switches is damaged.
Please observe local regulations
concerning noise protection.
Turning on and off
appliance well with both hands and
at some distance away from your
body. Before turning on the appli-
ance, check that it will not touch
any objects.
1. Check that the battery (16) is in
(see “Assembly instructions - In-
serting the battery”).
2. To turn on, use your thumb to
actuate the switch lock (3), then
press the On/Off switch (2). Re-
lease the switch lock.
3. To turn off, release the On/Off
switch (2). There is no continu-
ous operation mode.
After turning off the appliance,
the trimming assembly will keep
revolving for some time. Allow
the trimming assembly to come
to a standstill. Neither touch nor
slow down the moving cutting
insert. Risk of injury!
Trimmer
settings
The auxiliary handle can be set to various
positions. Adjust the handle such that the
cutting disk slightly tilts forward in your
