11
FITTING THE ASSIST HANDLE
Loosen and remove the wing nut and bolt from the assist handle.
1. Place the assist handle on the upper shaft. Adjust the handle to mount on the index channel as
shown (Fig. 5).
2. Along the index channel, slide the assist handle to the most comfortable position (Fig. 6).
3. Insert the bolt in the hole on the assist handle and tighten the wing nut securely (Fig. 7).
ASSEMBLY
Fig. 5
Fig. 6
Fig. 7
JOINING THE UPPER SHAFT TO THE LOWER SHAFT
1. Align the upper shaft with the lower shaft.
2. Insert upper shaft into the lower shaft and locking pin button into place (Fig. 8).
Never adjust the upper handle while the power head is running. Failure to
stop the motor may cause serious personal injury.
NOTE:
If the button does not release completely in the positioning hole, the shafts are not locked
into place. Slightly rotate from side to side until the button is locked into place.
WARNING
Fig. 8
Summary of Contents for GT1454
Page 19: ...19 EXPLODED VIEW...
Page 21: ...NOTES 21...
Page 39: ...39 VUE CLAT E...
Page 41: ...REMARQUES 41...
