MAINTENANCE
STORAGE
M10X10
O7.5X1.8
WARNING:
19
Fig.7
Store the Tiller/Cultivator in a dry, clean area out of reach of children.
During extended periods of storage, ensure that the tiller/ cultivator is protected against corrosion and
frost.
At the end of the season, or if the tiller/cultivator is not being used for longer than a month, wipe over
all metal surfaces with an oil impregnated cloth to protect them from corrosion or spray with a fine coat
of oil. Fold the guide bar down, and store the tiller/cultivator in a suitable place.
Injury can occur while working on the tines. Wear protective gloves. To
remove the complete tine assemblies from the shaft, remove the B shape
fixed pin
（
13
）
from the shaft. Remove the tine assembly from the shaft.
Reverse above steps to install tines.
ADDING TRANSMISSION LUBRICANT (FIG.7):
Drain screw plug is located on the right side of transmission housing. Lay the tiller/cultivator on its left
from user's perspective side and clean the transmission of dirt and debris prior to removing the drain
screw plug. If necessary, remove tine assemblies to have better access to the drain screw plug. Use
a 5mm hex key to unscrew the plug. Empty the oil from the transmission. Fill with a high-quality SAE
30 weight oil, until it begins to seep out around the hole. Reinstall the drain screw plug.
Summary of Contents for TE1016M
Page 13: ...O5 O5 M5X12 M6X57 M6X57 O6 O6 13 ASSEMBLY Fig 1 ...
Page 23: ...EXPLODED VIEW 68 67 70 66 65 64 23 ...
Page 25: ...NOTE 25 ...
