![background image](http://html1.mh-extra.com/html/lawo/crystal/crystal_user-manual_3953505085.webp)
crystal User Manual
Version: 6.6.0/2
85/459
7. Operation
7.10.5
Limiter
In the standard configuration, a separate limiter is available for all MIC sources and some of the other sources.
To check if the limiter is supported, press the source's
ACCESS
key and then look at VisTool - if the Limiter
graphs (and parameters) appear, then the DSP is available. Alternatively, look at the Central Module:
LIM
key lit
= limiter available.
Ø
To access the limiter parameters, press an
ACCESS
key followed by
LIM
on the Central Module.
Surface Controls (Limiter)
VisTool
The following parameters are available for the Limiter:
·
LIM
- on/off for the limiter: red = on.
·
THRS
- threshold from -93dB to +27dB.
·
RLS -
release time from 10ms to 5000ms.
The Limiter graph on VisTool includes a green ball which represents the output level of the Limiter. This
changes dynamically as the signal level varies, and so is extremely helpful when adjusting parameters.