diamond - User Manual
Version: 8.0.0/1
Exported on: 24 October, 2023
113
/
228
•
•
•
•
•
•
DSP parameters can be protected so that only certain users can make changes. If this is the case, then you must be logged
in (with DSP parameter rights) in order to open the relevant pages. The rights can be edited by an administrator of the user
access rights system.
3.
Adjust the parameters from either the surface or GUI.
On the surface...
The master controls (on the left) provide information and page switching:
The display shows the selected function (e.g.
Input
) and source (e.g.
Mic 01
).
If the processing section has a master on/off key, then this also appears here. (Applies to all DSP functions except
Input).
If there is more than one page of parameters, then a dot appears below the source name. This indicates the current
page and the number of available pages. Press down on the rotary control to step through the pages.
The remaining controls are used to adjust the parameters:
For switched parameters, press the soft key to turn the option on or off: lit (full) = on; lit (dim) = off.
For variable parameters, turn the rotary control to adjust the value - the current value is shown in the display. If a
second parameter is available, then push down and turn to adjust the second function. The dot indicates the current
function.
If a rotary control or soft key is unlit, then it has no function.
