diamond - User Manual
Version: 8.0.0/1
Exported on: 24 October, 2023
154
/
228
•
•
•
•
•
•
•
2. Use the buttons under 'Conference & N-1' as follows. If an option is greyed out, then the parameter is not available.
Conference
- touch this button to add or remove the source from the conference system. The button colors are the
same as on the surface (described below).
N-1 Return Level
- touch and drag anywhere inside the parameter box to adjust the N-1 level: either left/right or up/
down. Or use the on-
screen
+
and
-
buttons.
Codec Return Signal
- touch this field to select a signal from the dialog box. The following options are supported: N-1,
PGM 1 to 3, REC, AUX 1 to 4 and Tone. The on-screen meter can be used to confirm that signal is present.
On the surface...
The
Conf
key assigns
a source onto the conference bus. What the source receives depends on the status of the source
fader and that of the other conference
members.
The
Conf
key color indicates the current state. The colors used can be modified by the ON-AIR Designer. The following
colors are used in the standard configuration:
Dim white = conference off. Source receives PGM 1 minus themselves.
Full green (Conf prepare) = conference on and fader open. Source receives PGM 1 minus themselves.
Dim yellow (Conf active) = conference on and fader closed on a single
source. Source
receives PGM 1 minus
themselves.
Full yellow (Conf audio) = conference on and fader closed on more than one source. All conference members receive
the conference bus minus themselves.
