diamond - User Manual
Version: 8.0.0/1
Exported on: 24 October, 2023
44
/
228
3. From above, pull the module up to release it from the frame.
You can use the rotary controls to help get a good grip. Start by popping out the upper posts. Then use your hands to ease
the module up and pop out the lower posts. Take care not to crush any of the cables.
4.
Remove the three connectors: 1 x power and 2 x CAN bus, taking note of which cables are the CAN in and CAN out.
5.
Fit the replacement module in the reverse order.
Take care to push the module fully into the frame from above; it should snap into place.
6.
Replace all of the fixing screws (from underneath the frame) and tighten them securely.
The screws must be tightened to secure the module to the frame and ensure a good connection (for modules mounted
above a connector board).
