diamond - User Manual
Version: 8.0.0/1
Exported on: 24 October, 2023
103
/
228
6.7 diamond - Input Gain and Pan
The quickest way to adjust input gain, or the left/right pan position, is to turn the fader strip rotary control.
For a microphone source, two separate input gains are available: mic gain in the analog domain (before the A-D converter)
and channel gain in the digital domain (after the converter). For other source types, only the channel gain is available.
For a mono source, you can adjust the left/right pan position. This changes to input balance on a stereo source.
The gain ranges and other input parameters are described later. See Input & Pan Parameters.
Operation
The steps below describe how to adjust input gain and pan from the fader strip rotary
control.
1.
Turn
the fader strip rotary control to adjust the first parameter - you will see both its name (e.g.
Mic
gain) and value
(e.g.
45dB
).
2.
Press
down on the rotary control to step to the next parameter (e.g. channel
Gain
).
3.
Press
down again to reach the next parameter (e.g. left/right
Pan
).
4.
If
you keep tapping down, then the sequence repeats.
On a Ravenna source, the parameter sequence is extended to include the stream selection for the receiver.
Tip
: To interrogate parameters without making a change, touch the rotary control for 1 second - the display shows
the parameter and its current value.
