diamond - User Manual
Version: 8.0.0/1
Exported on: 24 October, 2023
166
/
228
Saving a Source Snapshot
In the standard configuration, source snapshots are saved from the 'Source Parameter' dialog box. This opens automatically
when a source is in access.
1.
On the surface, press a fader strip
Access
key to select the source you wish to save.
The 'Source Parameter' dialog box opens on the
GUI.
2. Select
Save
(from the top row of buttons) to open the 'Save Access' dialog box.
3. Enter
a snapshot name and, optionally, a comment. Then select
OK
.
The dialog box closes and the settings are saved.
If you enter the same name as an existing snapshot, then a confirmation box appears - select
Yes
to overwrite or
No
to
cancel.
As before, the snapshot is saved into the "User Snapshots" group. If other groups are available, then these can be
selected via the
more...
button (top right).
