diamond - User Manual
Version: 8.0.0/1
Exported on: 24 October, 2023
192
/
228
1.
2.
3.
1.
2.
3.
1.
2.
3.
7.7 diamond VX - Routing Page
The 'Routing' page can be used to edit the audio connections to the Power Core outputs. The page is divided into two
halves: Sources (on the left) and Destinations (on the right). The available sources and destinations are defined by the
configuration and are divided into categories using the side panel tabs.
To interrogate the existing connections:
Under 'Destinations', select an output category (e.g. Ravenna Outputs).
If a destination is connected, then the source name appears below the output. For example, PGM1 is connected to Rav
Out 01.
If a destination has no source, then you will see two dashed lines.
To make a connection:
Under 'Sources', select an input category and choose a source - the selection flashes in blue.
Under 'Destinations', select an output category and choose an
output -
the selection flashes in blue.
Press
Connect
- the connection is
made.
To disconnect an output:
Under 'Destinations', choose the output you wish to disconnect - the selection flashes in blue.
Under 'Sources', select
No Source
.
Press
Connect
- the source is removed.
