diamond - User Manual
Version: 8.0.0/1
Exported on: 24 October, 2023
220
/
228
Network
The
Network
tab provides access to the network settings for the frame's ETHERNET port.
Network Device
This section displays the port's Host Name (defined by the ON-AIR Designer configuration) and MAC address, plus the
network IP Address, Network Mask and Gateway (if used). The Link Speed and State show the speed of the connection and
its current status (up or down).
In User mode, all fields are non-editable. In Supervisor or Administrator
mode, you
can enter a new IP Address, Network
Mask and/or Gateway. If any settings are changed, you must
click
Apply
to save the changes. IP Address changes are
made immediately and so you will lose your browser connection once the settings are applied. To continue with the system
administration, enter the device's new IP address into your browser and login again (from the Login screen).
Network Settings
Using the fields in this area, you can enter the Domain Name of your network and DNS Name Server IP Addresses, plus the
settings for your network's NTP server. As above, remember to click
Apply
to save the changes.
To configure a NTP server, either enter its name in the Server Name box, or its IP Address in the Server Address box. If you
type "ntp.internal" in the Server Name box, the IP Address will be automatically filled.
