diamond - User Manual
Version: 8.0.0/1
Exported on: 24 October, 2023
40
/
228
4.4 diamond - Mounting the VX Modules
If the Virtual Extension is included, then each VX module is shipped separately. The VX modules must be mounted into the
frame, once the frame is installed. All VX modules are identical and so they can be mounted in any order.
Overview
The VX frame comes with special side profiles that hold each VX module. The profiles include two pre-drilled channels into
which the module slides. On the rear of each VX module are two fastening screws and two spring-loaded bolts that secure
the module to the frame: one screw and bolt for each side.
Once the VX module is installed, the viewing angle can be adjusted to one of three positions by loosening the two fastening
screws and gently tilting the display. This allows users to change the viewing angle to suit their own personal preference.
Click here to see how the user adjustment of the viewing angle should work.
Mounting Instructions
1.
On the rear of the VX frame, remove the two black circular stands from the end of the side profiles.
There are two stands to remove: one on the left and one on the right. The image below shows the left side.
2.
At the bottom of the VX module, loosen the fastening screws by turning the knurled-head end until the distance is
about 2-3mm.
There are two screws to loosen: one on the left and one on the right. The image below shows the left side.
