diamond - User Manual
Version: 8.0.0/1
Exported on: 24 October, 2023
85
/
228
6.2 diamond - Fader Strip Control
Any fader strip can control any type of source and, depending on the configuration, supports layer switching and fader
mapping. This enables lots of signals to be controlled by very few physical faders.
diamond supports two different layouts for its fader strip controls: either
Fader A
or
Fader B
. In each case, it is only the
physical layout that differs; there is no difference in the operation.
If the frame includes a
Rotary Fader Extension
module, then this adds 4 extra rotary controls to the fader strip. The
operation of these controls is described later. See Working with Extension Modules.
Controls Overview
Each fader strip is divided into the following areas.
5. Fader
Fader A
Fader B
The operation of the following controls is system-defined: rotary control
(1), Access key (3), Flip key
(4), fader (5) and
source display (7). The MF keys (2, 6 and 8) are defined by the configuration.
The Flip key
(4) can be configured as another
MF key if layer switching is disabled.
There are no differences in operation between the Fader A and B modules.
