diamond - User Manual
Version: 8.0.0/1
Exported on: 24 October, 2023
87
/
228
•
•
•
•
•
5. Fader
The fader adjusts the channel level from
-∞
to +9dB.
The fader is motorized and touch-sensitive. It also has a notch that is set to 0dB and an overpress function that is triggered
when you pull back on the fader.
The notch and overpress can be enabled or disabled, by the operator, from the Setup menu.
The overpress function is programmed by the configuration and is defined globally for all fader strips. In the standard
configuration, it triggers
PFL
(pre-fader listen).
6. MF Key 5b
This MF key is programmed by the configuration and is defined per source. Typically, it provides talkback to sources such
as Mics and Codecs.
7. Source Display
This display always shows the name of the source controlled by the fader strip, its input level and color.
In the standard configuration, the following options can be enabled or disabled from the 'Settings
→
Surface' dialog box (on
the GUI):
Show Icons in Fader Displays
- shows the icon assigned to the source.
Show Userlabels
- shows the two user label lines. The text can be edited by opening the user labels editor.
The images below show the four possible states of the 'Source Display'.
For Ravenna sources, the two user label lines show the Group and Stream name of the incoming stream. If a streaming
connection is in progress, then you will see its status: pending, tuning, etc. The source name, icon and color can be edited
using the ON-AIR Designer (under "Sources
→
Source Parm"):
Source Name = the "Display Name" field.
Source Color = the "Source Color" field.
Source Icon = the " Source Icon" field.
8. MF Keys 3 & 4
The two large MF keys are programed by the configuration and are defined per source. Typically, they are used to turn the
channel
ON
and activate
PFL
(pre-fader listen).
