20
19
6.
O P E R A T I N G T H E L A - Z - B O Y
REMOTE (LR)
Normal Operation
6.3. The backlit keypad of the LR will turn OFF if no
key is pressed for 8 seconds.
6.4. Your LR controls up to 10 devices. Press each
device key directly to select the first 5. Press the
"
SHIFT
" key and then a device key to select
another 5. When accessing a device programed with
the shift key the device icon will change to indicate
the new device (i.e. when using shift then TV, the
device icon will change from TV to CD.)
6.5. To enable / disable the key tones sound, press and
hold "
CHAN+
" and " " keys on the remote
simultaneously for 2 seconds until the blue LED
indicator flashes. If it flashes once, the "beep"
sound is enabled, if it flashes twice, the "beep"
sound is muted.
6.1. Once you have setup up the LR for your A/V
equipment, it works like your original remote
controls. To operate, just aim it at your equipment,
and press any key to illuminate the display. Then
press an appropriate device mode key. You will hear
a beep tone as confirmation of key touch.
6.2. Use the shift button when attempting to access
secondary devices. Please refer to the Key
Function Description. After you press the "
SHIFT
"
key all functions will stay in shift mode. Press shift
again to exit this mode.
7.
PUNCH THROUGH
You can activate certain functions like TV volume to be
operated in other modes such as SAT. This is referred to
as punch through. Please refer to the following
procedure for activating this function.
7.1. To activate the Punch through Channel setting:
7.1.1. Press and hold "
"
and "
VOLUME-
"
keys on the remote simultaneously for 2 seconds
until you hear two beep sounds. The blue LED
indicator lights continuously.
7.1.2. Enter the punch through code "1", "1", "1", "0".
The blue LED indicator will flash once and lights
continuously.
7.1.3. Press desired device mode key. (e.g. TV)
7.1.4. Press "
" key.
7.1.5. Press desired channel code device mode key (e.g.
SAT).
7.1.6. The blue LED indicator will flash
twice
and
setting punch through mode will exit if the setting
is activated.
7.1.7. Example: SAT channel is activated on TV mode.
7.2. To deactivate the Punch through Channel
setting:
7.2.1. Press and hold "
"
and "
VOLUME-
"
keys on the remote simultaneously for 2 seconds
until you hear two beep tones. The blue LED
indicator light continuously.
7.2.2. Enter the punch through code "1", "1", "1", "0".
The blue LED indicator will flash once and light
continuously.
7.2.3. Press desired device mode key. (e.g. TV)
7.2.4. Press "
CHANNEL-
" key.
7.2.5. The blue LED indicator will flash
twice
and
setting punch through mode will exit if the setting
is deactivated.
7.2.6. Example: Punch through Channel is deactivated in
TV device mode.
