12
11
2.
HOW TO SET UP YOUR LA-Z-BOY
REMOTE (LR)
2.1.
By entering Device Code
You may setup your La-Z-Boy Remote (LR) by the
following code entering instructions.
2.1.1. Turn on your device (e.g. TV).
2.1.2. Refer to the LR Infra Red DEVICE CODE LIST;
look up the 4-digit Device Code which
corresponds to the brand of your A/V equ ipm ent .
If there are more than one Device Code listed
under your brand, try from the first code.
2.1.3. Press a desired Device Mode Key (e.g. TV).
Device name icon is displayed with a frame.
2.1.4. Hold down "
"
and "
VOLUME-
"
on
the LR simultaneously for 2 seconds until you hear
2 beep tones. The blue LED indicator lights
continuously.
2.1.5. Use the number keys 0-9 to enter your 4-digit
Device Code. The blue LED flashes twice if successful.
Then try the function keys (e.g. TV) on the LR. If your
device (e.g. TV) responds to your activated function
correctly, you have entered the right Device Code.
Otherwise, repeat the above setup with the next available
Device Code until your device (e.g. TV) responds to your
activated function, and most keys work correctly.
* Simply repeat the above procedures to enter the
Device Codes for your VCR, SAT, DVD and other
Devices. (Remember to press a correct Device Mode
Key in step 2.1.3 above). For set up of secondary
devices, press "
SHIFT
" followed by the desired
device key then follow steps 2.1.4-2.1.5 above.
Suggestion:
-
If you cannot find a correct Device Code for your
equipment, refer to the section that follows: How To
Set Up The LR - By Searching Through the Library.
-
For future reference it is recommended to make a note
of your Device Codes on the label provided at the
bottom of the charging cradle after setting up your LR
correctly.
2.2.By Searching Through the Library
If you cannot identify a correct Device Code for your
equipment from the Device Code list, you may search
through the code library:-
2.2.1. Turn on your device manually (e.g. TV).
2.2.2. Press a desired Device Mode Key (e.g. TV).
Device name icon is displayed with a frame.
2.2.3. Hold down "
"
and "
VOLUME-
"
on
the LR simultaneously for 2 seconds until you hear
2 beep tones. The blue LED indicator lights
continuously.
2.2.4. Enter a corresponding Search Code from following
table. The blue LED indicator should flash twice
and go out immediately.
( e . g . p r e s s T V d e v i c e m o d e k e y, t h e n p r e s s
"
"
and "
VOLUME-
"
, and enter The TV
Search Code 0001.) The blue LED indicator should flash
twice and go out immediately.
2.2.5. Press the same desired device mode key again as in
step 2 above. (e.g. TV)
2.2.6. Hold down "
"
and "
VOLUME-
"
together simultaneously again for 2 seconds until
you hear 2 beep tones. The blue LED indicator
lights continuously.
DEVICE
TYPE:
SEARCH
CODE:
TV
0001
VCR/
LASER
DISC
0002
SAT
0003
CABLE
0004
DVD
0005
AUDIO
0006
CD
0007
HOME
THEATER
0008
