14
13
2.2.7. Aim the LR at your device (e.g. TV); press the
"
"
(power) key repeatedly every 1-2 seconds
until the device has been turned off. The blue
LED indicator will blink once each time you press
the "
" (power) key to indicate your remote is
scrolling thru the code library. Once your device
has been turned off, immediately press the same
device mode key (e.g. TV) to lock in the search
code and the blue LED indicator will flash 3 times
and go out immediately.
* Simply repeat the above setup procedures to search
the Device Code for your VCR, SAT, DVD and other
Devices. (Remember to press a correct Device Mode
Key and correct Search Code in step
2.2.2-2.2.7
above).
* For set up of secondary devices, press "
SHIFT
"
followed by the desired device key then follow steps
2.2.3-2.2.7 above.
Note:
-
The search process can take several minutes due to
the number of codes stored in the library.
-
You cannot search through the code library for
DVR devices. This code must be entered
manually from the device code list.
Important:
During set up mode, the blue LED indicator will blink six
times and the set up procedure will be terminated if any
of the following conditions occur;
-
No key has been pressed for more than 8 seconds.
-
An invalid code number has been entered.
-
An invalid key (not a numeric key) has been pressed.
You can press
Smart 1
,
Smart 2
or
Smart 3
to exit the
search mode at any time. The blue LED indicator will
blink six times to indicate your remote has exited the
search procedure.
....
....
Important:
When searching through the Library for some older
devices, if the power on/off function of your device is
not infra-red controlled you need to follow steps 2.2.2 to
2.2.6 above and start searching:
-
Press " " (power) key and another important
function key alternately until your device responds to
the expected function, press the same device mode
key (e.g. TV) to lock in the code.
-
Press " " (power) key & "
" alternately,
or;
-
Press " " (power) key & "
1
" alternately.
Note:
- Each time you press the " " (power) key, the LR
will skip to the next code and send out a POWER
signal trying to turn off your device.
-
If you failed to stop pressing the " " (power) key in
step 7 above and lock in the
code.
-
If the blue LED indicator flash 6 times after you
pressed the " " (power) key, you are already at the
last code of the library.
- Besides device keys, " " (power) key and " "
(mute) key, all keys can be operated if the remote has
entered search mode.
time when your device has been turned off, turn on
your device again immediately. Before the blue LED
indicator goes out, press " " (mute) on the LR to skip
backward. Repeat the
