15
16
3.
HOW TO SET UP YOUR LA-Z-BOY
REMOTE (LR)
By Learning Commands
Your LR is equipped with learning capability. This
allows you to "teach" your LR certain functions from
your original equipment remote. Please follow the steps
below.
3.1. Press the desired device mode key (e.g. TV). The
device name icon is displayed with a frame.
3.2. Hold
down
"
"
and "
VOLUME-
"
on
the LR simultaneously for 2 seconds until to hear
2 beep tones. The blue LED indicator lights
continuously.
3.3. Enter the learning code "0", "0", "0", "0". The blue
LED indicator flashes once and then stays lit
continuously. The LR is now ready to learn
commands. An icon " " will also appear at the
bottom of the screen.
3.4. Place the LR and your device remote on a flat
surface, aimed at each other 1-3 inches apart.
3.5. Press a desired key once and release on the LR
which you want to learn the command. The blue
LED indicator will flash once on your LR and
stays lit continuously.
3.6. Press and keep holding the key on your original
equipment remote which you want to learn for a
few seconds.
3.7. When the blue LED indicator flashes twice and
stays lit continuously, the command has been
learned successfully and you can release t h e k e y
on your original equipment remote. If the blue
LED indicator flashes
six times
, it shows an error
in the learning process. Adjust the position of both
remotes and repeat from step 3.5 again.
3.8
Repeat from step 3.5 to learn other key functions,
or press the same device mode key on step 3.1 (e.g.
TV) to terminate the learning mode, the blue LED
indicator will flash
twice
and then go out
immediately.
Note:
-
On step 3.5 if no key is selected for more that 8
seconds, the blue LED indicator will flash
six times
and the learning mode will exit automatically.
-
On step 3.6, if no other remote signal is received for
more than 8 seconds, the blue LED indicator flashes
six times
and stays lit continuously, you need to select
a desired key again for learning as in step 3.5 on your
LR.
-
Each function key will hold one command only, a new
command to be learned will automatically erase and
replace the previous one.
-
If the device mode indicators flash
three times
during
the transference of signals, the maximum 100
commands memory bank is full, press the same
device key again to resume normal operation.
-
All device mode keys, as well as the
SHIFT
,
Smart 1
,
Smart 2
and
Smart 3
keys cannot be used for
learning functions.
Learn
