Defender Press Brake Guarding System Operation Manual
LS-CS-M-069
Page 16
Original Language Version: 1.04
Released:
01/04/2020
If the new tool has changed the laser to punch distance, then the laser will not be aligned to
the slots in the alignment card. The example in
shows a laser that needs to be
moved down to return to alignment.
Hold the bottom of the transmitter unit with one hand, and with your other hand unscrew the
locking handle on the transmitter bracket to release the clamp. Slide the bracket up or down
until the laser is positioned in the slots on the transmitter alignment card. Then tighten locking
handle to secure the bracket. Remove the alignment card.
Figure 4-5: Laser To Punch Alignment
For the receiver you simply need to adjust the vertical position of the receiver bracket so the
laser is positioned near the middle of the window (
). In most cases, if the tool
height changes by less than 20mm, the receiver will not require any adjustment.
Figure 4-6: Laser Position on Receiver Window.
The mute point must now be cleared by the operator (see
Section 3.4
), and set again on the
first stroke with the new punch.
