Operating Instructions – LBAT10/20/PMR – Version 2017
27
9.3
Adjusting position sensors
9.3.1
Rotary sensor self-learning (revolving door(s))
In order to carry out the self-learning of the turnstile, the drum must first be positioned in one of its three
"stable" positions, that is to say when one of the three combs of the drum is in the extension of the fixed
comb, as in the image below:
By pressing on the PLC’s “ESC” + “UP arrow” keys, the turnstile's rotary sensor self learns.
The following message must appear on the PLC:
9.3.2
Adjusting the inductive sensor (gate for persons with reduced mobility)
The position inductive sensor is adjusted in the following way:
1-
Adjust the sensor so that it is activated (the sensor lamp should be lit) at about 2 mm from
the metal screw head
2-
The gate should then lock in closed position
3-
Once this is adjusted perfectly, tighten the nut using a 17 spanner
/ ! \
Self-learning
completed
successfully
/ ! \
