Operating Instructions – LBAT10/20/PMR – Version 2017
29
9.4.2
Commands and display
•
Local commands:
•
Turnstile status, counters and program version:
A message is shown on the screen when the PLC is operating. You can use the up
and down
directional arrows to display several different messages in the following order:
“Turnstile status”
: This message indicates the turnstile’s status
(locked, opened in direction 1, opened in direction 2, etc.)
“Counters”
: This message indicates the number of passages made
through the turnstile in both directions
(“Mill.” = millions of passages)
“Configuration”
: This message indicates the off configuration of the
turnstile and if this configuration has been changed
If “Inversion” states “On”, then the off configuration of the turnstile in
the direction in question (e.g., in this case, both directions are free off).
Command
Function
Up arrow/down arrow
Display of different messages then
counters then date and time
Right/left arrows
(from the date screen)
Display of inputs/outputs
ESC + Up arrow
Rotary sensor self-learning
Turnstile
Open
Direction 1
Passage counters:
Direction 1: 15
Mill. : 0
Direction 2: 23
Mill. : 0
Off Config.
by default:
Direction 1 free
Inversion?
Off
Direction 2 blocked
Inversion?
On
