LEAD PACK 14
(
LCG-B314IP)-User Manual
14
8. Operating Control Instruction
Master/Slave
When the fixtures work in master mode it will send out the signal for the slave synchronous
with it. To avoid the host signal and DMX512 signals interfere with each other, should cut off the
DMX512 signals. The signal lines are longer than 60 meters (20 lamps), should increase a signal
amplifier.
9. XLR cable connecting
XLR cable
：
The standard connection way of the XLR is: one end connects to the male plug, and the other
connects to the female. As below: pin 1: ground, pin 2:
negative signal, pin 3:
positive signal
Noted
：
In order to avoid failures and interference signal transmission
，
we connect a
resistance120Ω
（
1/4W
）
at the end of the DMX connecting as below:
The Conversion between 3 pin and 5 pin XLR
If the output cable of DMX512 controller is the 5PIN, please use 1pc 5PIN to 3PIN cable
