5
lci1.com
Rev: 04.27.21
Lippert BottleCheck (AU)
Installation and Owner’s Manual
(For Aftermarket Applications)
CCD-0004234
Alignment marks
Battery Replacement
Fig.8
Alignment marks
BATTERIES MUST ONLY BE CHANGED IN AN AREA
FREE OF IGNITABLE CONCENTRATIONS DUE TO
EXPLOSION HAZARD.
BottleCheck uses a CR2032 COIN CELL (3V) battery for
power. If it becomes necessary to replace the battery,
follow these steps:
1.
Remove sensor from the tank and move a safe distance
away from the tank.
2.
Insert a small flat head screwdriver into one of the
alignment marks between the lid and the base (
Fig.8
).
3.
Pry outward to begin releasing the lid from the base.
Continue prying at each alignment mark location until the
two halves separate (
Fig.9
).
Fig.9
Resources Required
•
CR2032 battery
•
Small, flat-head
screwdriver
4.
Remove the old battery and dispose of properly. Insert
the new battery with the positive side facing up.
5.
Place the two halves together and firmly press the base
and cover together to assure a solid connection.
6.
Refer back to the installation procedures to refit the
sensor to the propane tank.
Fig.7
Callout
Fig. 7 Descriptions
A
Buy additional sensors at local distributor
B
Help Page at local distributor
C
Allow push notifications
D
Upload Sensor Data
E
Device Search Filter
F
Sort Preferences
A
B
C
D
E
F
