Operation:
Starting:
1: Pull out transmitter antenna completely and open the cover.
2: Press the ON button (one of two) on the transmitter.
Wait about 4 seconds for engine to begin running.
3: Close the cover and retract the antenna.
Stopping
:
1: Pull out transmitter antenna completely and open the cover.
2: Press the OFF button (one of two) on the transmitter.
The engine will stop after 8 seconds.
3: Close the cover and retract the antenna.
Maintenance:
Battery Replacement:
1. Loosen the screws on the shell of the transmitter.
2. Replace the old battery with a new 23 Alkaline/ 12 Volt battery.
3. Reassemble the shell and tighten the screws.
Transmitter Replacement:
In the event that a replacement transmitter is required, please contact:
(place distributor contact information label here)
Warning:
1. Keep remote control in a dry environment, away from water.
2. Not intended for use by children.
ON
ON
OFF
OFF
Receiver
Shell
Brand &
Customer Code
Line Clip
Wire Jacket
Connector
Receiving Antenna
Connector
