12
DEUTSCH
Item description:
LDIPA424T
LDIPA412T
Remote bus:
Yes
Display elements:
Back: 4 x input signal clip LEDs, remote lock LED (red).
Front: “PROT”, “LIMIT”, “SIG”, “BRIDGE” and mute symbol LEDs Power On/Standby LED
Front panel controls:
Standby, On/Off switch (Power On/Off)
Rear panel controls:
Potentiometer for output volume. Amplifier channel mode: "PAR" (Parallel), "ST" (Stereo), "BRG" (Bridge).
Remote ON/OFF. Remote locking switch. Remote mode. Standby On/Off. Switch for preset A and B. Low-Z and
high-Z switch (Per pair of channels).
Inputs:
4 x balanced line inputs, remote bus audio input
Input connections:
6-pole terminal block, pitch 3.81 mm, remote ON/OFF RJ45, service connector micro USB type B
Outputs:
4 x powered speaker outputs: Low-Z (minimum 4 Ohm), high-Z (70 V and 100 V).
Fault detection: 2 x NO/NC relay outputs (connected).
Output connections:
Speaker outputs: 4-pole terminal block connections, pitch 5.08 mm.
Fault relays: 2 x 3-pole terminal block, pitch 3.81 mm.
Speaker cable diameter
Minimum diameter (max AWG) of cable cross section is 1.5 mm² (16 AWG)
Maximum diameter (min AWG) of cable cross section is 3.31 mm² (12 AWG)
Expansion slots:
Yes. For optional Ethernet or Et Dante cards
Cooling:
P temperature-controlled active two-zone cooling, with airflow from front to back/to the side
Operating voltage:
100 – 240 V
Mains fuse:
T10AL/100-120 V; T5AL/220-240 V
Inrush current OFF-standby:
2.8 A
Inrush current standby-ON:
0.5 A
Power consumption
in standby:
0.9 W
Power consumption
in sleep mode:
30 W
25 W
Power consumption
at full load:
1000 W
790 W
Operating temperature:
0 °C ... +40 °C (max. 60% relative humidity).
Width:
19" rack (483 mm)
Height:
1 HE (44.5 mm)
Depth:
425 mm (with terminal block connections)
Weight:
11.36 kg
8.7 kg
Rack distance to the
next device (height):
1 HE
Rack depth (required):
500 mm
Output specifications for the speakers, all outputs driven and loaded
Output power
(1 kHz at 4 Ohm):
4 x 240 W (1.5 second sine burst)
4 x 120 W (1.5 second sine burst)
Output power
(1 kHz at 8 Ohm):
4 x 120 W (1.5 second sine burst)
4 x 60 W (1.5 second sine burst)
Output power
(1 kHz at 16 Ohm):
4 x 60 W (1.5 second sine burst)
4 x 30 W (1.5 second sine burst)
Summary of Contents for IPA 412 T
Page 27: ......
