Astro 250 Wi-Fi RGBW, DMX 512+ RDM LED followspot - User’s Manual – 1.0
Luci della Ribalta srl, Via Berna 14, 46042 Castel Goffredo (MN) Italy
Tel. +39 0376 771 777 – fax +39 0376 772 140 – email
– web www.ldr.it
27
15. POSITIONING YOUR MOBILE DEVICE
Because the WI-FI signal emitted by the Astro covers a distance of approximately 15/18m (provided
there are no obstacles to its diffusion), you can choose to position your mobile device on the
provided mobile holder, or anywhere else within the range of transmission and actually have the
colour changing of the Astro remotely controlled by a second operator.
Should your device lose connection to the Wi-Fi signal the Astro will not switch off but be left
« frozen » at the last chosen settings.
In order to fit your mobile device to the supplied holder, move the red button at the rear of the
holder to the OPEN position, and, while keeping it pressed, rotate the red toothed wheel until the
desired opening of the 4 holding arms is reached and turn it again clockwise to close the arms and
have your mobile securely held. Rotate your mobile to the desired angle and operate the
followspot.
In order to remove your mobile from the holder, press the red button at the rear of the holder to
release the arms open.
16. RE-CHARGING YOUR MOBILE’S BATTERIES
A USB Port is provided on the rear of the Astro. This will allow you to re-charge your device while
the Astro is being operated, without risking to run flat on batteries during a show or having to rely
on an external power supply unit.
17. CLAMP-ON MOBILE DIGITAL DIMMER, supplied
The Astro Wi-fi is supplied with a clamp-on mobile digital dimmer, which is packed separately in a
plastic bag inside the box/flight case of the Astro. Please refer to the dimmer’s separate Instruction
manual provided in the packing to install and use it correctly.
18. FOCUSING
This fixture features a variable beam angle from 8° to 22°. The variable beam is modified by
adjusting the front and rear zoom lenses in relation to each other.
The front lens defines the beam spread, the rear lens defines the focus degree of ‘softness’ or
‘hardness’ of the beam edge or shutters.
19. CLEANING AND MAINTENANCE
To ensure maximum performance of the product, a regular maintenance service should be carried
out. Please make sure the product is cold and disconnected from power supply when doing this.
General maintenance
•
Clean all reflective parts such as lenses opening the product, if necessary.
•
Check the lenses and replace any visibly damaged component.
•
Clean air ducts and fans in order to allow proper ventilation activity on the product.
