Astro 250 Wi-Fi RGBW, DMX 512+ RDM LED followspot - User’s Manual – 1.0
Luci della Ribalta srl, Via Berna 14, 46042 Castel Goffredo (MN) Italy
Tel. +39 0376 771 777 – fax +39 0376 772 140 – email
– web www.ldr.it
5
5. BLACK SHUTTER BLADES (accessory, part nr. R80208019 x 4)
Black shutter blades are not supplied with the unit but are available as separate accessory. They are
sold as single items and relevant part number is R80208019, 4 are required.
6. ADJUSTING THE YOKE
This followspot is provided with a yoke balancing adjustment. The balancing point is factory set for
the standard product configuration supplied (without colour). However, should you need to adjust
the balancing, please follow the procedure below:
•
The followspot must be mounted on the tripod stand with all relevant accessories attached.
•
Using a Phillips screw driver, loosen the 2 M5 screws on each side of the yoke.
•
Gently slide the followspot backwards or forwards to the required position.
•
Make sure the yoke is correctly aligned horizontally.
•
Tighten the 4 M5 screws
7. WIRING
Before being connected to the mains power, this unit may need to be wired with a suitable plug if
not already installed. Make sure the plug you are using is rated for the proper power load.
•
This fixture must be grounded
•
Ensure the plug conforms to the relevant EU/UL or local electrical standards
To perform a correct wiring, please note that the cores in this mains lead are colour-coded as
follows:
Ground: green+yellow – Neutral: blue - Hot: brown
In case the colours of the wires do not correspond to the colour of the connection points on your
plug, please proceed as follows:
The green or green and yellow wire must be connected to the connection point marked with the
letter E or with the symbol or coloured in green or in green-yellow
The blue wire must be connected to the connection point marked with the letter N or with the
symbol or coloured in black
The brown wire must be connected to the connection point marked with the letter L or with the
symbol or coloured in red
Before you finally position this product for use, temporarily connect it to a properly fused power
supply to check the unit works correctly.
