Astro 250 Wi-Fi RGBW, DMX 512+ RDM LED followspot - User’s Manual – 1.0
Luci della Ribalta srl, Via Berna 14, 46042 Castel Goffredo (MN) Italy
Tel. +39 0376 771 777 – fax +39 0376 772 140 – email
– web www.ldr.it
7
In order to work properly with an external mobile device the Astro must be set in Wi-Fi mode at the
default settings. If default settings have been changed, please refer to chapter 10.23-B to reset the
product to factory settings.
Tap the rotary selector and the LCD screen will display the mode status and the current value:
10.2 DMX ADDRESS (Addr) :
It allows to select the initial DMX starting address to remotely control the LED functions. To change
the initial DMX address press the rotary switch until an arrow appears, then turn to change to the
desired DMX starting address. Press to confirm your selection. Factory setting is 001.
10.3 DIMMER RESOLUTION (8/16b) :
The dimming resolution can be controlled at 8 bits from one DMX channel to 16 bits with 2 DMX
channels.
Factory setting is 8 Bit.
10.4 LOST DMX SIGNAL (DMXMem) :
In case of signal failure this function allows to store in memory the last DMX value. This function is
forced ON in Wi-Fi mode. Factory setting is ON.
Three options are available :
2 Addr
001
PRESS TO ACTIVATE
THE MENU AN
ARROW SHOULD
APPEAR
1 Mode
WIFI_D
1 Mode
WIFI_D
←
1 Mode
DMX
←
TURN TO SELECT
Wi-Fi, MANUAL OR
DMX AND PRESS TO
CONFIRM
2 Addr
001
←
2 Addr
###
←
TURN TO ASSIGN THE
DMX ADDRESS AND
PRESS TO CONFIRM
3 8/16b
8 BITS
PRESS THE ROTARY
SELECTOR TO
ACTIVATE
3 8/16b
8 BITS
←
3 8/16b
16 BITS
←
TURN TO SELECT 8
OR 16 BITS AND
PRESS TO CONFIRM
PRESS TO ACTIVATE
THE MENU AN
ARROW SHOULD
APPEAR
M: DMX
XX %
M: WIFI_D
XX %
1 Mode
WIFI_D
1 Mode
DMX
TAP THE ROTARY
SELECTOR TO DISPLAY
THE VALUE
TAP THE ROTARY
SELECTOR TO DISPLAY
THE VALUE
00 % = LED OFF
100 % = LED FULL
00 % = LED OFF
100 % = LED FULL
M:Manual
XX % XXX
1 Mode
MANUAL
TAP THE ROTARY
SELECTOR TO DISPLAY
THE VALUE
00 % (000) = LED OFF
100% (FFF) = LED FULL