Installation
9. Have a third person raise up and hold the island range hood in position, connect power plug to the 12”
hanging electrical cord, and connect the duct work to the range hood.
10. Mount the hood to the lower support frame using four “D” bolts and four “E” nuts: Securely fasten two
“E” nuts to two “D” bolts by reaching up from the underside of the hood. Repeat this step to secure the
other side using two “E” nuts to two “D” bolts.
11. After all four “D” bolts and four “E” nuts securely fastened, connect the lower end of the duct tube to
the hood and slide the lower chimney cover down carefully so that it sits on top of the hood.
2. Install grease cup and aluminum filters then check the operation of the range hood.
Installation Overview
IMPOR
TANT
: M
inimum heigh
t = L
ongest c 1½-inch
A
E
B C
B C
D E
A
ir Mo
vement D
ire
ction
Upper support frame
Support frame extensions
(Hole to hole distance: ≈ -inch)
6” Round duct (exhaust)
Electric circuit box
Island mount
range hood
Motor housing
Re-circulating kit exhaust
(Re-circulating kit not shown)
A
Qty: 4PCS
B
Qty: 10PCS
C
Qty: 10PCS
F
Qty: 2PCS
Hex Key
Qty: 1 PCS
(Optional with glass canopy)
D
Qty: 8PCS
E
Qty: 12PCS
Glass Canopy
Screw Qty: 4 PCS
(Optional with re-circulat-
ing kit. Pre-installed when
kit ordered together with
range hood)
NOTE:
• A screws are designed for dry wall. Not to be used with any other types
of walls.
• A distance of 28” to 31” is recommended* between stove top and the
“D” “E” bottom of range hood.
• Always use first and second holes on the support frame extensions to secure
lower support frame.
*Due to different ceiling height configu-
rations, recommended height may not be applicable.
