ALWAYS REFER TO FLIGHT MANUAL FOR COMPLETE DETAILS
8)
CALIBRATION Part 2: Pull Left and Right Joystick inwards and hold for 3-5 seconds.
This completes the Gyro (accelerometer) calibration. For best performance, do this
step before every flight.
9)
EMERGENCY STOP: A safety feature is built into the controller. Never press the
STOP button in flight. The STOP button turns OFF engines immediately. Press and
hold stop key for 3 seconds to activate this safety feature. Only use in case of
emergency.
10)
START ENGINE
: To start the aircraft, you must complete the calibration procedures
and allow a few minutes for the aircraft to connect to the GPS. If all 4 LED lights on the
aircraft are on (2 White and 2 Red) you can engage engine on. Pull the left and right
joystick in opposite direction as indicated below. Aircraft rotor blades will begin
spinning.
11)
ONE KEY TAKE OFF BUTTON: Simple and safe launch of the aircraft at the push of
a button. Once engines are activated and rotor blades are spinning, press launch
button and the aircraft will self-launch to about waist height. The user can now take
control and begin flight.
12)
ONE KEY LAND BUTTON: A simple, soft landing at the touch of a button. Control
aircraft to a landing spot and then press the One Key land command button. The
aircraft will land and shut off engines.
13)
ONE KEY RETURN: Can’t tell which way is up or down, forward or backward? Use the
intuitive “Home” button and your drone will come back the spot where it launched
from. You will need to manually guide it down and press the one key landing button to
complete your flight.
For additional support visit http://www.le-idearc.com/contact-us_d3
