V 1.2
4
G300-Smart Specifications
Power Source Requirements
230VAC 2200W 50/60Hz
Internal Fusing
12 AT ceramic
Fluid Capacity
5 Litres
Output Modes Available
Smoke
Haze (only from firmware v2.00 and above)
Control (timed/cont.)
Manual
DMX Remote
DMX
0-10V
Wifi & Ethernet
sACN
LeMaitre MIP
Typical Smoke Output
1100 m
3
/min burst 500 m
3
/min continuous
Machine Dimensions
610 x 210 x 295 mm
Weight (Fluid Not Included)
18 kg
Fluid Use
Only Le Maitre® Ltd Smoke Fluids should be used. Use of other fluid may cause incorrect
operation and could cause toxicity issues.
C-Beam Haze fluid should only be used with the G300-Smart in Haze mode
Replacing fluid merely requires the changing the empty bottle for a new one. Use the screw lid
to seal the used bottle and dispose of correctly. Re-filling the empty bottle is not advised as
this can lead to the introduction of foreign particles which may reduce the efficiency of the
external in-line filter. If it is felt that there is a reduction in the performance of the machine
then this filter should be checked and cleaned. Never operate the machine with this filter
removed.
Any spillage should be cleaned away. The fluid does not require anything other than a water
based cleanser.
Although the G300-Smart has fluid out sensing, care should be taken to not run without
fluid for any length of time as this will cause pump failure.
Fluid pump priming should be performed at the maximum smoke output, to ensure a
quick and air lock free process.
