9
3. Operating the TINY-FOGGER
3.3 Mounting the TINY-FOGGER
3.4 Starting up
1) Pour the TINY-FLUID into the fluid bottle and firmly lock the bottle. Plug the
connecting spout of the fluid tubing into the quick connector of the fluid
bottle (audible click).
Check the cleanness of the connecting spout, so that no dirt (fluff etc.) can be
sucked in by the pump. Even the smallest impurity immediately leads to clog-
ging of the machine.
2) Plug the cable of the control panel or the cable of the radio remote (only, if
radio remote control was supplied)into the stereo jack socket at the machine
before you connect the TINY-FOGGER to the battery.
3) Connect battery cable to the battery.
4) Press start button at the control panel (black) briefly. After approx. 1 second
the unit generates fog according to the fogging time preset by the factory.
Caution:
The wires in the fog nozzle must not be damaged. Should these wires be
damaged, the unit will no longer work correctly when generating fog and the
vaporizer must be changed (see section 6.1).
If the Tiny-Fogger is to be built in props or similar, make sure that a fog-free air
supply is guaranteed. Too high a fog concentration can condense inside the
machine and can result in damages caused by moisture.
When installing the TINY-FOGGER make sure that
• no fog is passed back into the fog generator,
• no condensed fluid runs into the apparatus,
• the air vents (1) are not covered or concealed,
• no objects jut out into the fog nozzle (2) (danger of destruction of the fine
wires of the vaporizer).
