Water Tank Setup
•
Pour the bag of dry gel into the water tank.
•
Add distilled or carbon filtered drinking water into the water tank,
filling to the water line.
(
Overfilling the water tank may cause
ventilation issues and short circuits
)
•
Wipe off any excess water on the inside and outside of the fan unit.
•
Place the cover back on the water tank as shown above. Allow 20
minutes for the gel to absorb water before use.
•
Replace gel yearly.
(1)
Press and hold the 'MODE' button for 3 seconds until the RH
setting numbers flash in the bottom right of the screen.
(2)
Release the 'MODE' button and use the 'UP' and 'DOWN'
buttons to raise or lower the target humidity/RH setting.
The humidifier fan will turn on and off depending on what the
RH setting is set to.
Quickly press 'MODE' to switch from °C or °F.
Press 'UP' or 'DOWN' to display the Max/Min humidity.
When the water level becomes low, the LCD display will show 1
water drop and beep for 30 seconds. Push any button to turn
off the alarm early.
Fill the tank to the water line using distilled water. Overfilling
may cause ventilation issues and short circuits.
MODE UP DOWN
Initial Setup and Operations
