English
6.4. START UP
6.4.1. CHECK POINTS BEFORE STARTING
Do not use this machine if it becomes damaged
or wrongly regulated.
Use this machine for the purpose for which it was
designed. Any other use may be dangerous for the
user to the machine and for people, animals and
things you may have around.
Verify that :
- The machine completely and look for loose parts
(screws, nuts, etc.) and damages.
- The protector is properly attached to the machine.
- There are not fuel leaks.
- Verify that the disk or head is not damaged.
- Check the air filter is clean. Clean the filter if
necessary.
Press, repair or replace everything you need before
using the machine.
Do not use attachments on this machine out of our
recommendations because their use may cause
serious injury to the user, the machine and the people,
animals and things close to the machine.
Before starting the machine, remove the guard
protecting the cutting unit.
Before starting the machine make sure that all moving
parts of the machine are not in contact with any object.
6.4.1. START UP IN COLD
- Place the machine on a flat, stable surface to start it.
- Place the switch (3) in the position ¨I¨ (START).
- Press the primer bulb (8) several times (7 to 10
times) until the fuel reaches the carburetor.
- Move the air lever (7) to the cold start position. .
-
Press the safety lever (4) and, without releasing,
press the throttle trigger (2). Hold tight throttle
trigger and press the throttle ratchet (5), and then,
while pressing the ratchet (5), release the safety
lever (4) and the throttle trigger (2).
- Pull the starter rope until you hear the engine
start.
- Move the air lever to the normal working position.
- If the engine exploded but did not actally start
running, pull the start rope again until it starts.
- Allow the engine to warm up for approximately one
minute before starting to work with the machine.
6.4.3. STARTING THE MACHINE FROM HOT
Place the machine on a flat, stable surface to start it.
- Place the switch in the position START (“I”) .
- Move the air lever to the normal working position.
- Pull the start rope until the machine starts.
- If the machine does not start after pulling at the
rope a few times, please refer to the cold start up
section.
6.4.4. ENGINE STOPPAGE
- Let go of the accelerator and let the engine run at
idle speed for a few seconds.
- Stop the engine by displacing the switch from the
position to the ¨O¨ position (stoppage).
3
5
2
4
8
7
14
