15
kickback.
Follow the manufacturer’s sharpening and maintenance instructio
ns for
the saw chain.
Decreasing the depth gauge height can lead to increased
kickback.
INTENDED USE
The chain saw is intended for sawing of trees, tree trunks,
branches, wooden beams, planks, etc. Cuts can be sawed with or
across the grain. This product is not suitable for sawing mineral
materials.
ASSEMBLY
Installing guide bar and saw chain
Open the box and install the guide bar and the saw chain on the
power unit as follows.
WARNING!
The saw chain has very sharp edges. Use protective gloves for
safety.
The saw chain and bar are packed separately in the carton.
Chain and guide bar
Use only the guide bar (13) and saw chain (14) according to the
technical data of the product.
1.
Set the product on a suitable flat surface.
2.
Before removing, ensure the chain brake is disengaged. If in the engaged
position, pull the front hand guard/brake lever
(11) backwards until it ‘clicks’
into position.
3.
Use the provided spark plug wrench (32) to remove the two retaining nuts
(16) from the side of the cover (18).
4.
If necessary adjust the tension pin (22b) by moving the tension screw (22a)
with the screwdriver (33) in or out until it reaches a position where the pin
can be inserted into the lower hole on the guide bar (13) (Fig. 3).
5.
The guide bar (13) should be fitted with the sa
w chain ‘cutter’ symb
ol at the
top of the bar (Fig. 4).
