28 Safety
To confirm misalignment, you will have to check the status of the proximity switch light: ON when
the tailgate is completely closed (switch is triggered), OFF when it is open. If the switch light stays the
same whether the taigate is open or not, you will have to adjust the switch. Apply the following
procedure to have this corrected.
To adjust the proximity switch:
1.
Loosen the proximity switch nuts.
2.
Adjust the proximity switch so that there is a gap of approximately 3/16
inch
(4.8
mm)
between
the plate (target) and the switch.
3.
Tighten up the nuts.
4.
Test the operation.
The proximity switch light should turn ON when the target is detected; if not, repeat the adjustment
procedure.
If, after several attempts, the switch does not work properly, replace the faulty switch with a new one.
Locking Out and Tagging Out the Vehicle
For any inspection, repair or general maintenance being done on the vehicle, whether on the road or
at the shop, it is the employer’s responsibility to establish and see to the application of a proper
lockout and tagout procedure.
To lock out and tag out a 2R-III™ unit:
1.
Park the vehicle on safe, level ground and apply the parking brake (see Figure 2-14).
Figure 2-14 Parking brake button
2.
Make sure that the body is completely unloaded.
3.
Switch off the hydraulic pump.
4.
Turn off the engine, remove the key from the ignition, store it in a safe and controlled area
(preferably on yourself), and tape over the ignition switch.
5.
Turn off and lock the master switch.
Switch
Nuts
Summary of Contents for 2R-III
