10
Do not leave the engine idling for more than 5 minutes
Avoid using a continuous speed between 3500 and 4500 rpm to protect unit
from vibration.
The exhaust system remains very hot after use
Starting up
Before starting up, make sure the trailer is in a stable position that its brake is on and the wheel blocks are in place.
On uneven ground, use stabiliser stands
(see 4.6).
•
Check the fuel and motor oil levels before starting up.
•
Check that the emergency stop is not pushed down (it is unlocked by rotating it).
•
Check that the fuel primer valve
[17]
is on
“ON”
position.
•
Put the battery cut-off switch
[1]
on
“1”
: The control panel should illuminate.
•
Adjust the required angle and elevation using the joysticks
[11]
and
[12].
•
Check that all indicators
[13],
[14]
and
[15]
are green.
•
Put the accelerator
[9]
at... minimum.
•
Turn the ignition
[2]
to
“ON”
after having lifted the cover.
•
Press the starter
[3]
for a maximum of 5 seconds.
•
Once the engine has started, make sure the oil pressure indicator is green and that the pressure on the dial
[10]
is sufficient (approx. 6 bar (87Psi)).
•
In order to protect the engine, only increase engine power once the temperature
[8]
has reached 50°C (122°F).
The engine speed must be between 1300 rpm (±100) when idling on a cold engine and 6900 rpm (±100) at full power.
Stopping
•
Reduce the engine speed to the minimum
[9].
•
Turn the ignition
[2]
to
“OFF”.
The engine should stop.
•
Adjust the angle
[11]
and elevation
[12]
to
“0”.
•
Put the battery cut-off switch
[1]
on
“0”.
•
Let the engine cool for a few minutes.
•
Stow the accessories (exhaust duct, wheel blocks, etc.).
Summary of Contents for 160.30.109
