11
Connecting the remote control deactivates the slope, elevation and engine power
controls on the main console.
Never connect or disconnect the remote control. when the motor is running.
Remote control
The remote-control option allows the
EASY 4000
to be remotely controlled. It is fitted with a 13m cable. The use of
this accessory makes it possible to adjust the slope, the elevation and the engine speed. After having connected the
remote control, these 3 functions are no longer active on the main console. The
"STOP"
command on the remote
control makes it possible to turn off the motor.
1-Slope:
Used to change the angle from -10° to +20°.
2-Elevation:
Used to raise and lower the ventilator (option).
3-Engine power:
Used to regulate the ventilator speed.
4-Stopping the motor
: Used to stop the engine using the remote control. Unlike the console emergency stop, it
will not stop the slope or elevation controls.
Setting up
•
Connect the remote control to the connector near the console
•
Check that the
"STOP"
button has not been pushed
•
Set the engine power to the minimum on the remote control and the console
•
Resume the start-up procedure
(see.4.2)
Run out of petrol
After a run out of fuel, you must priming the fuel pump following the procedure:
•
Check the fuel and motor oil levels before starting up.
•
Check that the emergency stop is not pushed down (it is unlocked by rotating it).
•
Put the battery cut-off switch
[1]
on
“1”
: The control panel should illuminate.
•
Put the priming valve
[17]
on
“FUEL PRIMER”.
•
Turn the ignition
[2]
to
“ON”
after having lifted the cover and turn off it after 4 seconds.
•
Begin again 3 times.
•
Put the priming valve
[17]
on
“ON”.
•
Turn the ignition
[2]
to
“ON”
after having lifted the cover and turn off it after 4 seconds.
•
Begin again 3 times.
•
Doing the starting up procedure
(see.4.2).
Remote control socket
1
4
2
3
Summary of Contents for 160.30.109
