To install the Heater Module, follow the steps below :
•
The Heater module is designed with a heater and a thermostat, connected by an 45,72cm cable, power
cord and ground wire (see image below)
Power Cord
Thermostat
Heater module
Ground cable
•
Prep the area where you will be placing the modules by using an alcohol/water mixture to clean the cabinet
of any particles or foreign debris. This will ensure solid adhesion of double stick tape to the powder coated
aluminium.
•
The heater device should be placed in the bottom of the rear panel with the thermostat placed on the
opposite corner. Since heat rises, this is the most effective location to have the unit work most efficiently.
•
Peel the adhesive tape strip from the back brackets and securely push the module into place. The adhesive
will hold the module in place and cure solid withing 72hours.
•
This is a high performance heater. Please leave horizontal and vertical clearance for optimizing natural
convection and avoid placing directly below heat sensitive components.
•
Do not allow electrical wires to come in contact with the body of the heater or directly in front of the hot air
outlet
Grounding
To avoid shock, the heater module should be grounded by attaching the grounding lug to the screw located on
the power receptacle bracket. Unscrew the screw closest to the ground cable and slip the grounding lug under
the screw before securing it back in place. NOTE: The LE-WPE6065TV100 & LE-WPE7075TV100 will require the
use of the ground wire extension cable to provide enough length to reach the power receptacle bracket.
Simply attach extension cable to ground cable on heater module using screw and bolt provided.
