■
OPERATION
5-32
5-11-6
Modification of pattern data with the
EDIIT
knob
Ex. Changing from the pattern data 3 to Null
1
Press
the
PAT CODE
key.
PAT/CODE
PAT/CODE
3
Modify the value with the
EDIIT
knob.
Turn the knob counterclockwise by five steps.
■
NOTE
The
EDIIT
knob can be turned endlessly. Turning the knob clockwise increases the
pattern data number, while turning it counterclockwise decreases the pattern data
number. Turning the knob clockwise at the Sc position ([
・
] displayed) causes the
pattern data 0 to be selected. Turning the knob counterclockwise at the pattern data 0
causes the pattern data Sc to be selected.
5-11-7
Selecting a sub-carrier phase
For RDS signals, a sub-carrier phase can be set to either 0° or 90°.
Ex. Setting a sub-carrier phase of an RDS signal to 90°
1
Press
the
SHIFT
key.
2
Press
the
RDS PHASE
key.
3
Enter a sub-carrier phase with the data keys.
9
0
■
NOTE
If a wrong value is entered, confirm the entered value once, and then repeat the setting
operation from the procedure 1.
4
Press
the
ENTER
key.
deg
■
NOTE
When an TRI signal is turned ON, the sub-carrier phase of an RDS signal is fixed to
90°.
When a sub-carrier phase may be entered (as described in the above procedure 3),
turning the
EDIIT
knob toggles a sub-carrier phase between 0° and 90°.
