15. MULTI-SCREEN DISPLAY
164
F•5
MULTI → F•7 LOWER: STATUS / AUDIO / 5BAR
15.2 Setting the Measurement Mode
The multi-screen display inherits the 1-screen display settings with a few exceptions.
For video-signal-waveform, CINELITE, vector, status, and audio displays, the display settings
can also be configured from the multi-screen display by following the procedure below. Such
settings are linked to the settings in 1-screen display.
The settings for the picture display (except for the line selection function), WFM INTEN,
VECTOR INTEN, and SCALE INTEN are not inherited from the 1-screen display. Note that
WFM INTEN set with MULTI WFM is linked to VECTOR INTEN set with MULTI VEC and
SCALE INTEN set with MULTI WFM is linked to SCALE INTEN set with MULTI VEC.
Procedure
*
F•* represents any of the function keys
to
and varies depending on the displayed contents.
15.3 Selecting the 4-Screen Multi Display Format
When
MODE is set to 4SCREEN, to set the content shown in the lower left of the screen,
follow the procedure below.
Procedure
Settings
STATUS:
The status is shown in the lower left of the screen.
AUDIO:
Audio is shown in the lower left of the screen.
5BAR:
5 bar is shown in the lower left of the screen.
LOWER = AUDIO
LOWER = 5BAR
Figure 15-3 Selecting the 4-screen multi display format
MULTI → F•* MULTI WFM
→ F•* MULTI CINELITE
→ F•* MULTI VEC
→ F•* MULTI STATUS
→ F•* MULTI AUDIO
F•2
F•1
