5. SYSTEM SETTINGS (SYS)
45
5.7
Initialization
To initialize the LV 5380 settings, access F•1 INIT in the system menu.
SYS
→
F•5 next menu
→
F•1 INIT
→
Figure5-9 INIT menu
5.7.1
Initializing the Settings
To initialize the settings, follow the procedure below. For information about the initial
settings, see section 16.1, “Menu Tree.” The initial settings are underlined.
To cancel the initialization of the settings, press F•3 INIT CANCEL.
Even if you initialize the settings, the date, time, presets, display mode presets, remote
control settings (option), and CINELITE II gamma correction values (option) are not
initialized.
Procedure
SYS
→
F•5 next menu
→
F•1 INIT
→
F•1 INIT YES
5.8
Setting the Menu Display Time
To set the menu display time (in five second steps), follow the procedure below. Setup menus
automatically disappear after a set period of user inactivity (menus do not automatically
disappear if OFF is selected.)
Regardless of the display time setting, the system menu, preset registration menu, and
preset menu do not disappear because of user inactivity.
Procedure
SYS
→
F•5 next menu
→
F•2 MENU AUTO OFF
→
F•D 1 TIME SET
Settings
Setting range:
5 to 60 s. / OFF (The default setting is 10 s.)
5.9
Remaining Battery Power Display (Option)
When you are using a battery, you can display the approximate amount of remaining battery
power in the upper right of the display using four levels.
Table 5-2 Indications of Remaining Battery Power
Display
Color White
White
Yellow
Red
Power Full
Low
