7. AUDIO DISPLAY
106
7.1
Setting the Signals to Measure
To set the signal to measure, follow the procedure below.
Here you can select input signals and assign channels.
Procedure
AUDIO
→
F•1 MAPPING
Figure 7-2 AUDIO MAPPING tab
Table 7-2 AUDIO MAPPING tab explanation
Item
Description
INPUT
Set the input signal to SDI or EXT AUDIO.
If both Audio BNC settings are set to Output in the system settings, you
cannot select EXT AUDIO.
SDI: The embedded audio signal applied to SDI INPUT is measured.
EXT AUDIO: The external audio signal applied to DIGITAL AUDIO INPUT is
measured.
3G-B STREAM SELECT
If INPUT is set to SDI, select the 3G-B stream.
This is invalid when the input signal is not 3G-B.
LINK SELECT
If INPUT is set to SDI and multi link or 12G is used, select the link.
DOLBY
(option)
During single input mode, turn the Dolby signal measurement on or off.
When turned on, Dolby E, Dolby Digital and Dolby Digital Plus are
automatically detected and measured.
MIX
(option)
When DOLBY is set to ON, turn mix mode on or off.
For details, see the next section, “Mix mode.”
DECODE CH GROUP
(option)
When DOLBY is set to ON, select the decode channel.
If INPUT is set to SDI and MIX is set to OFF, CH9/10 to CH15/16 cannot be
selected.
CH MODE
Select the number of measurement channels.
If INPUT is set to EXT AUDIO and if either Audio BNC setting is set to
Output in the system settings, you cannot select 16ch.
Summary of Contents for LV 5480
Page 15: ...2 VIDEO SIGNAL WAVEFORM DISPLAY 7 SCALE UNIT HDV SDV SCALE UNIT HD SD SCALE UNIT 150 ...
Page 38: ...2 VIDEO SIGNAL WAVEFORM DISPLAY 30 COLOR MATRIX XYZ COLOR MATRIX GBR COLOR MATRIX RGB ...
Page 98: ...5 PICTURE DISPLAY 90 STATUS INFO ON Figure 5 34 Turning the information on and off ...