8. STATUS DISPLAY
130
●
Cable (1A to 1D on the SER01/SER02 only)
The input signal attenuation is converted into a cable length that you selected and
displayed.
Normally the value is displayed in light blue, but by setting Cable Error on the ERROR
SETUP1 tab to ON, if the value exceeds the specified Warning value, it will change to
yellow. If the value exceeds the Error value, it will change to red.
The display range is shown below. The accuracy is ±20 m.
3G: < 10 m, 10 to 105 m, > 105 m
(5 m steps)
HD: < 5 m, 5 to 130 m, > 130 m
(5 m steps)
SD: < 50 m, 50 to 300 m, > 300 m
(5 m steps)
Reference ERROR SET
UP1 tab → section
8.2.1, “Error Setup 1”
●
Embedded Audio
The channels of the audio packets embedded in the input signal are displayed here.
If the input signal is 3G-B-DL, only stream 1 is displayed. (When measuring 3G-B-DS,
stream 2 is also displayed.)
●
ERROR
The counts of the errors for the items whose detection setting was set to ON with F•5
STATUS SETUP are displayed here. Errors are counted once per second or once per field.
The maximum number of errors that can be counted is 999999.
Switching video formats or input channels may cause disturbances in the signal that will
cause errors to be detected.
•
CRC (Other than SD)
An error is counted when the CRC embedded in the input signal is different from the CRC
that the LV 5490 detects.
•
EDH (SD only)
An error is counted when the EDH packet contains an ancillary data error flag, an active
picture error flag, or a full-field error flag and when the CRC in the EDH packet is different
from the CRC that the LV 5490 calculates from the video data.
•
TRS Pos
Input signal TRS (Timing Reference Signal) errors are displayed here.
An error is counted when the EAV (End of Active Video) and SAV (Start of Active Video)
header word (3FFh, 000h, and 000h) locations are wrong and when the F, V, and H TRS
protection bits do not conform to the video standard.
•
TRS Code
Input signal TRS (Timing Reference Signal) protection bit errors are displayed here.
An error is counted when the F, V, and H protection bits in the XYZ word in the EAV (End of
Active Video) and SAV (Start of Active Video) packets and the response to the P3, P2, P1,
and P0 error correction flags do not conform to the video standard.
Summary of Contents for LV 5480
Page 15: ...2 VIDEO SIGNAL WAVEFORM DISPLAY 7 SCALE UNIT HDV SDV SCALE UNIT HD SD SCALE UNIT 150 ...
Page 38: ...2 VIDEO SIGNAL WAVEFORM DISPLAY 30 COLOR MATRIX XYZ COLOR MATRIX GBR COLOR MATRIX RGB ...
Page 98: ...5 PICTURE DISPLAY 90 STATUS INFO ON Figure 5 34 Turning the information on and off ...
